What Should I Check Around My Home Before Replacing an Appliance?
Q: I’m ready to replace one of my appliances. Besides the opening where it goes, what else should I check around my home before delivery?
A: Before you replace any major appliance, it helps to check the entire path from your driveway to the final install location — not just the space where the appliance will sit. That means measuring doorways and hallways, thinking through tight turns, noting low ceilings or hanging fixtures, and watching for floor height changes. A few minutes of planning can prevent big headaches on delivery day.
1) Measure exterior doors first
Start at the most likely entry point (front door, garage door, side door, etc.):
- Measure the usable width of the doorway (not just the frame).
- Check how far the door can open and whether a storm or screen door reduces clearance.
- If you have multiple entry options, measure them all — sometimes the “alternate” door is the easiest route.
2) Measure interior doorways and hallways
Walk the full path from the exterior door to the appliance location and note the tightest spots:
- Measure the narrowest interior doorway along the route.
- Measure hallway width, especially where there are turns.
- Look up: low ceilings, ceiling fans, hanging lights, or décor can be a surprise for tall appliances.
Tip: If you’re not sure what “counts,” measure anything that the appliance and a dolly would have to pass through.
3) Watch for tight turns and obstacles
Some homes have plenty of straight hallway width but become tricky at corners. Pay special attention to:
- Hallway corners where a large appliance needs to pivot
- Stairways, railings, posts, and banisters that reduce maneuvering space
- Furniture, rugs, décor, and wall hangings that might need to be moved temporarily
It’s often the turn — not the doorway — that causes the biggest delivery challenge.
4) Check flooring height changes
Flooring transitions can create unexpected “steps” that make rolling equipment harder:
- Look for transitions between tile, laminate, carpet, and wood.
- Note any spots where the appliance must pass over a threshold or raised trim.
- In kitchens and laundry rooms, confirm new flooring didn’t make the opening smaller than it used to be.
Florida note: Tile-to-laminate transitions are common in our area, and even small lip differences can matter for heavier appliances.
5) Confirm space around the final install location
At the install location, look beyond the “cutout” and confirm the surrounding area will work on delivery day:
- There is room to open doors fully (refrigerators, ranges, washers, dryers).
- There’s enough space to pull the old unit out and maneuver the new one in.
- Nearby outlets, water lines, shutoff valves, drains, and vents are accessible.
For appliance-specific opening measurements, see the Appliance Measurement Help Center, including refrigerator measurements and dishwasher measurements.
6) Plan for pets, kids, and vehicles
Delivery goes smoother when the home is safe and the path is clear:
- Secure pets in a separate room for everyone’s safety.
- Clear driveways/garages so the truck can park and the team has easy access.
- Move vehicles if the appliance needs to come through a garage or carport.
7) Share concerns with Beacon ahead of time
If you already know there’s a tight corner, narrow staircase, or unusual layout:
- Let Beacon know when you purchase your appliance.
- Share photos of the path and the tightest areas (doorways, corners, stairs, and the final location).
Beacon’s friendly technicians in yellow and delivery partners can plan the safest and most efficient way to bring your new appliance inside.
More measurement & planning help
For appliance-specific measuring guides, visit the Appliance Measurement Help Center, including: